In this video, i’ll go through all the steps on how to properly solder a “vertical” pipe.
Amazon affiliate links to all the products I used in this video:
AutoCut Pipe Cutter 1/2″: https://amzn.to/2XlyqAn
AutoCut Pipe Cutter 3/4: https://amzn.to/2GZFrkf
Superior Tool 1/2″ Cleaning Attachment: https://amzn.to/2kwBMBK
Pencil Torch: https://amzn.to/2U3OTaa
Handheld Torch: https://amzn.to/2VhGujo
Fitting Wire Brush 1/2″: https://amzn.to/2BOlNVc
Fitting Wire Brush 3/4″: https://amzn.to/2U33enp
Propane gas(Blue bottle): https://amzn.to/2BOhnh7
Propene gas(Yellow bottle): https://amzn.to/2BPcdBl
Lead-free tinning flux: https://amzn.to/2U3abEW
Lead-free flux(water soluble): https://amzn.to/2XjaYn9
Flux brushes: https://amzn.to/2T8ROBc
Lead-free solder: https://amzn.to/2yPvjso
Flame protector: https://amzn.to/2Vh8q7o
Flint striker: https://amzn.to/2XiuX5y
Abrasive pads: https://amzn.to/2NnA9QP
Pencil reamer: https://amzn.to/2tBuhKW
All-in-one deburring tool: https://amzn.to/3B9dLUv
DISCLAIMER: Got2Learn is NOT responsible for any damage done to a property of which the plumbing wasn’t done by a professional, I do not recommend doing your own plumbing if you are unsure about what you are doing, always hire a LICENSED contractor when doing any type of plumbing so you can be covered by insurances if something does happen, these videos are for entertainment purposes only!
This content was originally published here.
